Go ![]() | New ![]() | Find ![]() | Tools ![]() | Reply ![]() | ![]() |
![]() |
And they say they have the screwdriver that he used to break the rifle down. With a sporterized Mauser like that, where you don't have the barrel bands to contend with, there's only two screws to take out to separate the barreled action from the stock. If he had practiced that at all he could've done it in about a minute, maybe less. ![]() ______________________________________________________________ I am Brutus. Or, Lord Brutus if you prefer. | |||
|
FYI--I have the exact same setup Tyler had, but without top mounted scope rings and scope. There are two screws that hold the bottom plate, mag-spring and follower and trigger guard onto the stock. They could be screwed together and unscrewed. it doesn't take a special screw driver to take it apart--but Mauser screws are not regular screws. You should be using a gunsmithing screw driver that has flared gripping blades (optimal) but you can use a regular screw driver as well. The action, bolt and barrel are on the top section and could be broken down and reassembled--and with a 142 yard shot, with a scope pre-zeroed taking it apart and together again is not going to throw it off that much. Taking off the scope and unscrewing the barrel (if you could that is--takes special tools) yes, absolutely. But still broken down you have a 30 inch package you have to conceal. He did this atop the roof after the shot? Now how much time did he spend in the bushes putting it all back together again? if it were broken down into a backpack, why didn't he just keep it inside and walk back to his car? And did he break the rifle down atop the roof or after he jumped down? I wonder where this Mauser originated from. German. Polish. Bruno (Chech), Turkey? There's lots of places they were made under licensing. Or if it was a civilian model--actually made by Mauser itself. As for the loads (ammo) used we can only speculate until they release more information. My 30-06 Mauser is Polish with a precision peep sight adapted to the receiver instead of a scope. I also do a lot of precision reloading for .308 175 grain Hornady XMatch moly-coated. And .308 is nearly identical ballistically to 30-06. except the case is shorter. It's all very hinky. | ||||
|
Fifth Column Freeper![]() |
Very thorough synopsis. | |||
|
![]() |
Yeah, my old Czech VZ-24 is still in military configuration except for the removal of the original rear sight and the addition of a Lyman peep sight on the rear receiver ring. Still has the full military stock with barrel bands, etc., so it's a lot harder to remove the barreled action from the stock and takes quite a bit longer. Mine even has the main screw with locking screw set-up still in place where the small screw is supposed to keep the larger screw from backing out. That's another detail that he wouldn't have had to contend with. Almost surely that sporter stock was set up with just a single screw in each of the two attachment points. As far as the make is concerned, it could've been just about any of the various Mauser K-98 or K-98k makes that are out there. About the only one it probably would *NOT* be is the Yugoslavian, which have what is termed an "intermediate length" action. On those a .30-'06 conversion *MIGHT* work, but would probably be a bit tight where length is concerned. In comparing .30-'06 to .308, where '06 really comes into its own is in the heavier bullet weights at longer ranges. The "identical ballistics" thing comes mostly from the consideration of the M2 ball loading of the '06 with the 150 grain bullet that was common in WWII and Korea. If you go back to the M1 ball load with the 174 grain bullet, '06 definitely has "better legs" than .308. The main reason the military moved from the M1 load to the M2 load was a shortage of rifle ranges that had sufficient space available for an adequate safety fan in the downrange area for the heavier M1 bullet, which would travel further than the M2. ![]() ______________________________________________________________ I am Brutus. Or, Lord Brutus if you prefer. | |||
|
Yeetcow![]() |
Supposedly the surgeon who examined Kirk's body at the ER told Erika that there was no exit wound, and that the bullet (or fragments thereof) were visible under the skin on the back of his neck. Kirk's cervical spine was destroyed by the round, but I think we all agree that a 30.06 can easily pass through flesh and a little bit of articulated bone and leave one hell of an exit wound. So, no exit wound, and this is what has fired off discussion in the shooter community over on the clock app and X. My thought was either an underloaded or dud round. I load my own hand gun ammo, and yes, I know you are shocked, but I occasionally spit out a few duds, usually due to bad primers. It happens. Like everyone, I am waiting on some kind of official report, which I think is forthcoming, but may end up being a fairy tale. Keep an open mind, but not so open your brain falls out. ______________________________ Don't pet the fluffy murder cow. | |||
|
Fifth Column Freeper![]() |
Hope you are correct. However, I am very skeptical of the whole affair. Something smells. | |||
|
![]() |
My money is on a frangible bullet load, possibly handloaded by the Robinson family. ![]() ______________________________________________________________ I am Brutus. Or, Lord Brutus if you prefer. | |||
|
Yeetcow![]() |
Makes sense to me. It's the only thing so far. ______________________________ Don't pet the fluffy murder cow. | |||
|
Fifth Column Freeper![]() |
Fireball over California - did the US just nuke someone? Fireball reported over California this evening. West coast has nuclear capable missiles. Mercury E6 was headed for Travis AFB, then turned around, headed out for the Pacific. That's the TACAMO plane which is a nuclear command and control plane. [link to fox40.com (secure)] recommended by | |||
|
Powered by Social Strata | Page 1 2 |
![]() | Please Wait. Your request is being processed... |
|